ASTEK HIGH PERFORMANCE COLD PATCH

PRODUCT INFORMATION

PRODUCT INFORMATION

ASTEK High Performance Cold Patch is a high quality, pre-mixed, asphalt "cold patch" compound. Combining a carefully selected aggregate with a special bitumen formula.

ASTEK High Performance Cold Patch is highly recommended for spot repairs to driveways and dry pavement with no loss of bonding ability. The most important benefit to remember is the fact the ASTEK High Performance Cold Patch is the "Permanent Patch" and should remain in the repaired area indefinitely. Money will be saved in labor costs because, workers will not be constantly repairing an area where a other types of "cold patch" asphalt mix was used

More

COVERAGE

COVERAGE

Depth and width of pothole, crack, utility cut etc. will greatly influence the coverage rate achieved. As a rule however, a three gallon pail of ASTEK High Performance Cold Patch will fill a two inch deep hole, four square feet is size.

 

More

PREPARATION

PREPARATION

Simply sweep out the area to be repaired with a bristled brush or broom. It is a good idea to remove any loose debris, dirt, ice, or standing water from the area to be repaired. This action will promote good adhesion and bonding. More

APPLICATION

APPLICATION

No heating or mixing is required. Simply shovel into the pothole, crack, or rut, straight from the container. If the fault is especially deep, i.e. over six inches, apply in two inch layers, compacting each layer in succession. Shovel enough material into the fault to slightly crown the "patch". When completed, compress the "patch" with the pneumatic tamper. Area can be opened to traffic immediately. More

STORAGE

STORAGE

The depth and width of the area to be applied plays an important role in the variability of the application amount. As a general rule, a 25 kg ASTEK High Performance Cold Patch Material can repair a 25x25cm hollow area with a depth of approximately 4-5cm. More

COLOR

COLOR

Black More
+90 (312) 467 85 15
info@asfaltkaplama.com
Follow us!